Facades and Stone Sealer
based on Silanes, Siloxanes and Fluorades
Compounds, Water Based, For Interior/Exterior Use

Ready to use water and oil repellent colorless solution based on fluorides, silanes and siloxanes.

Penetrates inside pores, does not form a surface film or change the natural appearance of the materials, allowing the surface to breath. Effective water repellent protection on vertical and horizontal alkaline surfaces including porous floors. Prevents efflorescence, frost damage and formation of mildew and moss. Suitable for porous materials such as natural stones, concrete, bricks, porous marbles, porous ceramic tiles, concrete baths and showers. Do not use on non – porous materials.

Available Sizes : 0.75l, 3l

Performance Features

  • Water repellent effect on vertical and horizontal alkaline surfaces
  • Does not form a film, does not change the appearance
  • Leaves a breathable surface
  • Prevents efflorescence, frost damage and formation of mildew and moss

Colors : Milky, dries clear. Do not tint.
Toxicity : Formulated without lead or mercury
Gloss Level : Matt

Performance Guide

  • Weather Resistance : Excellent resistance to weather
  • Water Resistance : Excellent resistance to rain and condensation
VOC (Volatile Organic Compounds): 099 Facades & Stone Sealer: belongs to the category A/c WB (exterior walls of mineral substrate) . EU Limit: 40g/l (2010). This product contains zero (0) VOC.

Spreading Rate : 5-7 m²/L depending on surface porosity
Volume Solids : 4.50%
Wet Film Thickness : Minimum
Dry Film Thickness : Minimum
Dry Time at 20°C : 1 hour to touch
Flexibility : Not applicable
Thinning : Do not thin. Ready for use.
For Application By : Brush, Roller, Spray

Surface Preparation

  • Surface must be clean, dry (or slightly damp), free of dust, dirt, grease, salts and mildew.
  • Cover and protect adjoining areas.
  • Cover plants.
  • Do not apply
    directly on sunlight.
  • Stir product prior of using.


  • Apply generously with soft brush or roller, for larger areas apply by spray, until the substrate is saturated and a
    fluid film runs down the building surface.
  • On horizontal surfaces the application can be done by a squeegee.
  • Excessive material must be removed.
  • Equipment Cleaning: Clean equipment in warm, soapy water.
  • Note: If a second coat is required it must be applied while first coat is still wet (wet on wet application). Recoat is allowed after 6 months.

Precautions Health, Safety and Environmental Protection:

If medical advice is needed, have product container or label at hand. Keep out of reach of children. Do not get in eyes, on skin, or on clothing. Avoid release to the environment. Dispose of contents and container to appropriate waste site or recycled in accordance with local and national regulation. Keep container tightly closed. Contains 1,2-benzisothiazol-3(2H)-one and reaction mass of 5-chloro-2-methyl-4-isothiazolin-3-one and 2-methyl-2H-isothiazol-3-one (3:1). May produce an allergic reaction.







Pin It on Pinterest

Share This